Tidal Engineering Synergy Series Technical Manual page 206

This output is used when cooling is required with humidity control
Output is either Time Proportioning or On/Off
L7 Ambient Cooling Turn On
L8 Heat Ambient Cooling Turn Off
L9 Ramp Up Cooling
Control Parameters
Channel 2 Proportional Band Heating
Reset for Channel 2 Heating
Rate for Channel 2 Heating
Cycle Time for Channel 2 Heating
Rate Band for Channel 2 Heating
Channel 2 Proportional Band Cooling
Reset for Channel 2 Cooling
Rate for Channel 2 Cooling
Cycle Time for Channel 2 Cooling
Rate Band for Channel 2 Cooling
Synergy Controller Technical Manual, Revision H
Ambient Device
Percent cooling required to turn on the cooling
compressor
Percent heat required to turn off the cooling compressor
Temperature at which the cooling compressor is turned
off while heating
Default Value:
42
0.02
0
1
0
40
0.1
0
7
0
Range:
0 - 50 Degrees C
0 - 9.9 Repeats/minute
0 - 9.9 Minutes
1 - 60 Seconds
0 - 7 Seconds
0 - 50 Degrees C
0 - 9.9 Repeats/minute
0 - 9.9 Minutes
1 - 60 Seconds
0 - 7 Seconds
Page 206