Tidal Engineering Synergy Series Technical Manual page 233

Description Command Usages
EVENTS Set
Event Output Control
(Single Event)
EVENTS Query
EVENTS Query
Event Output Query
(All Six Events plus Relays)
WF*_TOL Set
Waitfor Tolerance
WF*_TOL Query
REMOTE_START_ENAB
LED Set
Remote Start
REMOTE_START_ENAB
LED Query
Synergy Controller Technical Manual, Revision H
Command Syntax Range,
Units
= EVENTS ARG1:
Event # (1-6)
ARG2:
0 - Disabled,
Enabled
? EVENTS ARG1:
Event # (1-6)
? EVENTS Returns a 32 Bit hex number.
Each bit represents an event
Bit 1 = Event 1
Bit 2 = Event 2
Bit 3 = Event 3
Bit 4 = Event 4
Bit 5 = Event 5
Bit 6 = Event 6
Bit 23 = Relay 1
Bit 24 = Relay 2
=WF*_TOL ARG1 -50 to 50 C (-90 to 90 F), -50 to
50%
? WF*_TOL -50 to 50 C (-90 to 90 F), -50 to
50%
= ARG1:
REMOTE_START_ENABL 0 - Disabled, 1 - Enabled
ED ARG1
? 0 - Disabled, 1 - Enabled
REMOTE_START_ENABL
ED
Command
Example
= EVENTS 1 1
1 -
? EVENTS 1
? EVENTS
=WF1_TOL 5
? WF1_TOL
= REMOTE_START_ENABLED
1
? REMOTE_START_ENABLED
Response Example
OK
1
00C00001
OK
5
OK
1
Page 233
Page 233