Fc Port Diagnostics; Bus Feedback - Danfoss VLT AutomationDrive FC 360 Programming Manual

Parameter Descriptions
8-57 Profidrive OFF2 Select
Select control of the frequency converter OFF2 selection via the
terminals (digital input) and/or via the fieldbus. This parameter is
active only when parameter 8-01 Control Site is set to [0] Digital
and ctrl. word and parameter 8-10 Control Word Profile is set to [1]
Profidrive profile.
Option:
[0] Digital input
[1] Bus
[2] Logic AND
[3] Logic OR
*
8-58 Profidrive OFF3 Select
Select control of the frequency converter OFF3 selection via the
terminals (digital input) and/or via the fieldbus. This parameter is
active only when parameter 8-01 Control Site is set to [0] Digital
and ctrl. word and parameter 8-10 Control Word Profile is set to [1]
Profidrive profile.
Option:
[0] Digital input
[1] Bus
[2] Logic AND
[3] Logic OR
*
8-79 Protocol Firmware version
Range: Function:
Size related [0 - 65535 ] The version of the protocol firmware.
*

4.9.6 8-8* FC Port Diagnostics

These parameters are used for monitoring the bus
communication via the FC Port.
8-80 Bus Message Count
Range: Function:
0 [0 - 65536 ] This parameter shows the number of valid
*
telegrams detected on the bus.
8-81 Bus Error Count
Range: Function:
0 [0 - 65536 ] This parameter shows the number of telegrams
*
with faults (e.g. CRC faults), detected on the
bus.
8-82 Slave Messages Rcvd
Range: Function:
0 [0 - 65536 ] This parameter shows the number of valid
*
telegrams addressed to the slave, sent by the
frequency converter.
MG06C402
Programming Guide
8-83 Slave Error Count
Range:
0
*
8-84 Slave Messages Sent
Function:
Range:
0
*
8-85 Slave Timeout Errors
Range:
0
*
8-88 Reset FC port Diagnostics
Option:
Function:
[0]
[1]

4.9.7 8-9* Bus Feedback

Use the parameter group to configure the bus feedback.
8-90 Bus Jog 1 Speed
Range:
100 RPM
8-91 Bus Jog 2 Speed
Range:
200 RPM
Danfoss A/S © Rev. 2014-03-31 All rights reserved.
Function:
[0 - 65536 ] This parameter shows the number of error
telegrams, which could not be executed by the
frequency converter.
Function:
[0 - 65536 ] This parameter shows the number of messages
sent from the follower.
Function:
[0 - 65536 ] This parameter shows the number of follower
time-out errors.
Do not reset
*
Reset counter
[ 0 - 1500 RPM]
*
[ 0 - 1500 RPM]
*
4
Function:
Function:
Function:
73
4