Danfoss VLT AutomationDrive FC 360 Programming Manual page 39

Parameter Descriptions
1-93 Thermistor Source
Option: Function:
NOTICE
This parameter cannot be changed
while the motor is running.
NOTICE
Digital input should be set to [0] PNP -
Active at 24 V in 5-00 Digital I/O Mode.
Select the input to which the thermistor
(PTC sensor) should be connected. An
analog input option [1] Analog Input 53 or
[2] Analog Input 54 cannot be selected if the
analog input is already in use as a reference
source (selected in parameter 3-15 Reference
1 Source, parameter 3-16 Reference 2 Source
or parameter 3-17 Reference 3 Source.
[0] None
*
[1] Analog Input
53
[2] Analog Input
54
[3] Digital input
18
[4] Digital input
19
[5] Digital input
32
[6] Digital input
33
[7] Digital input
31
MG06C402
Programming Guide
Danfoss A/S © Rev. 2014-03-31 All rights reserved.
4 4
37