CRUISE CONTROL SYSTEM
CRUISE CONTROL INSPECTION
1. Disconnect the negative battery cable.
2. Remove the driver-side air bag module. (See DRIVER-SIDE AIR BAG MODULE
REMOVAL/INSTALLATION .)
3. Disconnect the audio control switch connector. (See AUDIO CONTROL SWITCH
REMOVAL/INSTALLATION .)
4. Inspect for resistance and continuity between cruise control switch terminals BC using a tester.
If not as specified, replace the cruise control switch. (See AUDIO CONTROL SWITCH
•
REMOVAL/INSTALLATION .)
Switch condition
ON/OFF button pressed
CANCEL button pressed
SET/COAST button pressed 666694
RES/ACCEL button pressed 2,1562,244
No button pressed
Resistance (ohm)
Continuity
117123
No continuity
(w)
Engine Specifications
Page 237