Abus SECVEST FUAA50 Series Installer Manual page 82

Configuration
Type
Zone Omit (System)
Entry Exit Follow
Locking actively unlocked
Open/Close
Zone Follow
Indoor lighting
Installer on Site
Walk Test
82
Explanation
(Output only functions when confirmation mode DD243 or
BS8243 is selected.)
When there is an unconfirmed alarm the alarm panel re-
arms when the confirmation time has expired.
When the zone that triggered the unconfirmed alarm is
still open at the time of rearming, the alarm panel omits
this zone and activates this output.
The alarm panel restores the zone and resets the output
when a user or installer resets the system.
This output is activated for the duration of the delay time
(entry delay or exit delay).
The output is not activated if the partition has been config-
ured in "Instant Set" or "Silent Set" mode.
A zone lock exists.
The alarm panel activates the output as soon as a zone
with type "Zone Lock" is triggered and deactivates the out-
put when the zone is closed.
The output is activated when the system (or partition) is
disarmed.
It is deactivated when the system (or partition) is armed.
If this output is assigned to more than one partition, it is
deactivated as soon as one of these partitions is armed or
internally armed.
Note: the function of this output is already inverted by de-
fault compared to the other outputs.
There are 0 volts at this output when the system is dis-
armed.
This output follows the status of a zone.
If this type is selected, an overview of the zones is pro-
vided.
Select a corresponding zone.
This output is activated while the entry/exit delay time is
running and deactivated 10 seconds after the entry/exit
delay time has expired.
The output is activated as soon as the alarm panel is in
installer mode and deactivated as soon as the installer
has successfully exited this menu.
The output is activated when a user starts a walk test both
as an installer and as a normal user.
The output is also activated in the time between an alarm
being muted and the alarm confirmation.
Can be assigned
to partitions
Yes
No
Yes
No
Yes
No
No