S/W Upgrade; Software Upgrade With New Files On The Pc - Abus SECVEST FUAA50 Series Installer Manual

S/W upgrade

Note
SW >=3.00.03
There are two ways to perform a software upgrade.

Software upgrade with new files that are saved on the PC.

Software upgrade with new files that are stored on the FTP server.

Software upgrade with new files on the PC

Important
Saving and restoring the configuration
As part of a comprehensive update, the Secvest wireless alarm system is reset to the factory defaults.
It is therefore essential to save the alarm control panel configuration in advance:
1st "Installer Mode" web server
2. "System"
3rd "Backup/restore"
4. "Backup"
After completing the update, the configuration (inc. all component IDs) can be restored:
5. "Installer Mode" web server
6. "System"
7. "Backup/restore"
8. "Load Configuration"
Important
SW >= 3.00.06, saving and restoring the configuration
Before the alarm panel starts the upgrade, the configuration files and the SSL certificate are saved automatically on
the internal flash drive. The new software is then installed, and the alarm panel restarted. At this point, the factory set-
tings are used first, but the alarm panel then automatically reproduces the configuration files and the SSL certificate
from the flash drive (as if the configuration had been saved/reproduced manually). This means that the Start Wizard is
not used, the SSL certificate is not regenerated and, more importantly, that the installer does not have to go to the site
in order to respond to the command prompt of the Start Wizard.
Important
Changes have been made to the following menus as part of S/W 2.00.00

VoIP Dialler Setup

Contacts -> SIP User ID

Outputs -> Type "User defined"

ARC/ESCC reporting -> IP port
Please check these menus after carrying out the configuration and adjust the settings accordingly.
Appendix
269