Abus SECVEST FUAA50 Series Installer Manual page 270

Appendix
Remote Updates
Preparation:
Adding new "Level 4 user"
Alarm panel
Installer Mode -> System -> Security -> Remote Updates -> Enabled
Or
WBI
Installer Mode -> System -> Security Settings -> Remote Updates -> Enabled (activated, ticked)
If this option is activated, a new Level 4 code must be entered. This is only the case if this Level 4 code was
never programmed to begin with (as delivered or since the last reset to the factory defaults). This Level 4 code
has the same number of digits as the Installer code or the User code.
Enter a "New Level 4 code" and "Confirm Level 4 code" (enter the code again to confirm it).
A new user is added automatically. See "User" menu.
Name: "Level4"
Note:
For security reasons, you should change the "Level4" default name of the Level 4 user.
Note:
Further details can be found under the menu explanations in the corresponding instruction manuals.
270