Abus SECVEST FUAA50 Series Installer Manual page 104

Configuration
Name/function
Beep on Set
Beep on Unset
Int. siren time [min]
104
Explanation
On
After successfully internally arming the partition, there is one acoustic acknowl-
edgement on the wireless external siren.
"Siren" outputs are activated for 10 s after successfully arming the partition.
Off
After successfully internally arming the partition, there is no acoustic acknowledge-
ment on the wireless external siren.
On
After successfully disarming the partition, there is one acoustic acknowledgement
on the wireless external siren.
"Siren" outputs are activated for 10 s after successfully arming the partition.
Off
After successfully disarming the partition, there is no acoustic acknowledgement on
the wireless external siren.
Time for the duration of the internal siren(s) in minutes after a burglar alarm.
The siren time can be set to a value between 0 and 20 min.
If sounders are assigned to multiple partitions, the alarm panel uses the longest si-
ren time set for the partitions in question.
The time for which the sounders are active can also be extended to the longest si-
ren delay for that partition.
Note
Internal sirens always sound after a fire or hold up alarm until the alarm is confirmed
by a user for safety reasons. For safety reasons there is no time limit for a fire alarm
or hold up alarm.
Special response when an entry delay is used
Requirement
 The internal sounders (alarm panel, wireless indoor siren, wireless info module)
are muted again after the internal siren time has expired.
 The alarm panel has automatically rearmed (see also "Installer Mode  System -
> Security  Auto Rearm").
Response
 If you now enter the entrance area ("Final Door" and "Entry/Exit Follow" detectors
are opened), the internal sounders (alarm panel, wireless indoor siren, wireless
info module) emit an alarm tone.
 The normal entry tone is not signalled in this case.