Role
Voice dialler
SMS
Meaning
Speech Dialler must be activated.
Installer Mode->Communications->Speech Dialler->Call Mode->Enabled
A list of the available connected transmission paths can be seen:
Ethernet
Once this has been selected, enter a valid SIP User ID.
e.g. +498207123456789@sipgate.de
Press the "OK" button.
The alarm panel establishes a connection. If the call is answered by this recipient, the re-
cipient hears the "Home Message" and "Message 1" to "Message 4".
S/W >=2.00.00
When this is selected, the configured recipients are displayed with their contact names as
stored in the phone book.
Scroll to the desired contact. Press the "Select" or "Start" key in the web interface.
The alarm panel sends a test call to this recipient.
PSTN
When this is selected, enter a number to dial.
Press the "OK" button.
The alarm panel establishes a connection. If the call is answered by this recipient, the re-
cipient hears the "Home Message" and "Message 1" to "Message 4".
S/W >=2.00.00
When this is selected, the configured recipients are displayed with their contact names as
stored in the phone book.
Scroll to the desired contact. Press the "Select" or "Start" key in the web interface.
The alarm panel sends a test call to this recipient.
GSM / Mobile
When this is selected, enter a number to dial.
Press the "OK" button.
The alarm panel establishes a connection. If the call is answered by this recipient, the re-
cipient hears the "Home Message" and "Message 1" to "Message 4".
S/W >=2.00.00
When this is selected, the configured recipients are displayed with their contact names as
stored in the phone book.
Scroll to the desired contact. Press the "Select" or "Start" key in the web interface.
The alarm panel sends a test call to this recipient.
If "Call Acknowledge" is activated:
The recipient can acknowledge and end the call with 5 or 9 respectively if the following is
set: Installer Mode->Communications->Speech Dialler->Call Acknowledge
->Enabled.
During the test call a series of progress messages appear on the display.
If the test call was not successful, the display shows a brief message with the cause of the
error.
Text messages must be activated and the contact must be saved in the phone book.
Installer Mode->Communications->SMS->Call Mode->Enabled
A list of the available connected transmission paths can be seen:
Configuration
223