Table of Contents
Advertisement
3.2.14 CPU board
The CPU board controls amongst other the remote power on/off mechanism between the
its host and the transmission of a genlock signal.
Connectors
On the CPU board there are two RJ-45 connectors for connecting the remote power on/off cables.
Do not remove the sheet metal plate. The connector behind is reserved for diagnostic
purposes.
Connecting order remote power on/off
Each A
O
B
should be connected to its host for the remote power on/off mechanism. Therefore the
RGUS
MNI
US
remote power on/off connector [16] on the back of the host (
connected with the remote power on/off in connector of the CPU board of the O
vices are connected in a daisy chain to their host by connecting the remote power on/off out connector of the
first O
B
to the remote power on/off in connector of the next xt O
MNI
US
on/off out connector of the last O
Do not mix up the connetors for remote power on/off with the mechanically identical
connectors of the network adapters!
Mixing the connectores will cause damage to the system.
Barco – Argus X Terminal – DOC-3265-2 – user's manual – Revision 04 – May-2004
[16] on the back of the host (A
B
remains unconnected.
MNI
US
/off mechanism between the O
P
or rendering processor) must be
RGUS
ROCESSOR
MNI
B
and so on. The remote power
MNI
US
________________________________________________________________________
3. Getting started
B
devices and
MNI
US
for diagnostic
Figure 3-34
connectors of CPU board
B
. Multiple O
B
de-
US
MNI
US
Figure 3-35
cabling for remote power on/off
3-26
Advertisement
Table of Contents
