Barco Argus X Terminal User Manual page 131

Restore procedure
Whenever it is necessary to go back to a saved configuration or to restore the working partition, one out of two
possible procedures can be performed.
Either:
•
When booting A
RGUS
when the system comes up, please refer to section
the lilo prompt appears. This is dependent on the settings chosen by means of the boot loader utility,
please refer to section
Or:
•
is running, enter into the command line service eosxs with the option restore to boot
When A
RGUS
from the backup partition:
service eosxs restore
In both cases you have to be logged in locally on the A
Before the restore procedure actually starts, date and time of the backup is displayed and you will be prompted
to confirm the restore procedure by typing y.
Following that, the A
RGUS
partition that is stored on the backup partition to the working partition. This means that the currently used
working partition becomes overwritten. When copying is finished, A
from the working partition and is therewith operable again, based on the state of system and configuration from
the time of the backup.
Whenever booting from the backup partition the content of the working partition becomes
overwritten with the backup. This means the current content of the working partition gets
lost!
Barco – Argus X Terminal – DOC-3265-2 – user's manual – Revision 04 – May-2004
the option backup can be selected. It either must be selected from the graphical menu
4.8.3 Boot loader utility.
boots from the backup partition. After booting it copies back the version of the working
This means the current content of the working partition gets
3.3.2 Switching on or the option must be typed as soon as
and the X server must not be started.
RGUS
reboots automatically, this time it boots
RGUS
________________________________________________________________________
4. Operating
4-57