Table of Contents
Advertisement
3.2.14 CPU board
The CPU board controls amongst other the remote power on/off mechanism between the O
its host and the transmission of a genlock signal. It is part of each O
Connectors
On the CPU board there are two RJ-45 connectors for connecting the remote power on/off cables.
Do not remove the sheet metal plate. The connector behind is reserved for diagnostic
purposes.
Connecting order remote power on/off
Each O
B
should be connected to its host for the remote power on/off mechanism. Therefore the remote
MNI
US
power on/off connector [16] on the back of the host (P
distributed system) must be connected with the remote power on/off in connector of the CPU board of the
O
B
. Multiple O
B
MNI
US
MNI
on/off out connector of the first O
on. The remote power on/off out connector of the last O
Do not mix up the connetors for remote power on/off with the mechanically identical
connectors of the network adapters!
Mixing the connectores will cause damage to the system.
Barco – TransForm A - X Terminal – DOC-3265-2 – user's manual – Revision 09 – September-2006
devices are connected in a daisy chain to their host by connecting the remote power
US
B
to the remote power on/off in connector of the next O
MNI
US
B
.
MNI
US
in a monolithic system, rendering P
ROCESSOR
B
remains unconnected.
MNI
US
cabling for remote power on/off at O
_____________________________________________________
3. Getting started
B
devices and
MNI
US
Figure 3-39
connectors of CPU board
in a
ROCESSOR
B
and so
MNI
US
Figure 3-40
B
A18 devices
MNI
US
3-31
Advertisement
Table of Contents
