Barco Argus X Terminal User Manual page 162

To set up networking, enter the IP address and netmask and if needed a default gateway and the primary name-
server and confirm with OK. If in doubt about the network settings ask your network administrator for the values.
When navigating through the dialog and leaving empty the fields for the default gateway or primary name
server, there will be default values entered automatically into the empty fields. To overcome this the F12 key
can be pressed instead of the OK button.
The setting BOOTP/DHCP is not supported by Argus. If you have selected it by accident, use
linux conf to assign a valid IP address, please refer to section
When the installation is finished you are prompted to press the <Enter>
The system will reboot now. Remove the CD from the drive as soon as the drawer ejects it. After this system
installation you have also to run through
distributed system through
logical screens.
Barco – Argus X Terminal – DOC-3265-2 – user's manual – Revision 04 – May-2004
BOOTP/DHCP is not supported by Argus. If you have selected it by accident, use
Remove the CD from the drive as soon as the drawer ejects it. After this system
3.4.1 System configuration
3.4.3 Configuring a distributed system
6. Advanced configuration
3.4.1 System
Enter> key to reboot A
and 3.4.2 X.11 configuration
or 3.4.4 Configuring a distributed system with multiple
________________________________________________________________________
configuration!
Figure 6-19
.
RGUS
Figure 6-20
and if you have a
6-19