Switching Resolution Of Graphic Cards - Barco Argus X Terminal User Manual

6.1.5 Switching resolution of graphic cards

The appropriate resolution is selected with a rotary switch on the board. The figure above shows this rotary
switch located on top of an inserted graphics card. All cards must be set to the same resolution! The following
table shows the possible settings:
switch projection module
0 O V - L
VER IEW M
1 O V - L
VER IEW M
O V - D
VER IEW M
O V - E
VER IEW M
2 O V - L
VER IEW M
4 O V - P
VER IEW M
A 67C4-PSI
TLAS
modules older than Q2/03
5 O V - P
VER IEW M
A 67C4-PSI
TLAS
O V - E
VER IEW M
6 digital output: 60 Hz VESA timing gital output: 60 Hz VESA timing
7 O V - P
VER IEW M
A 67C4-PSI
TLAS
modules from Q2/03 and newer
8 O V DR50/67-DL
VER IEW M
9 A CS4, S70
TLAS
digital output via DVI connector l output via DVI connector
F digital output with DDC
connected display device provides
DDC information
analog output (CRT) with DDC
connected monitor provides DDC i d monitor provides DDC in-
formation.
analog output (CRT) without DDC
(1) For O V
VER IEW M
Nevertheless in a set up where DDC can not be evaluated, switcher position 8 can be used instead.
For AGX Graphic Cards switcher position 7 and 8 is only available with BIOS revision FMW- GX Graphic Cards switcher position 7 and 8 is only available with BIOS revision FMW-
3000-06 or newer and switcher position 9 is only availabe with BIOS revision FMW-3000-08 000-06 or newer and switcher position 9 is only availabe with BIOS revision FMW-3000-08
or newer.
The Version of the BIOS revision is printed on the mikrocontroller on the graphic card. Version of the BIOS revision is printed on the mikrocontroller on the graphic card.
Barco – Argus X Terminal – DOC-3265-2 – user's manual – Revision 04 – May-2004
Q2/03 and newer
(1)
DR50/67-DL 67-DL usually the switcher position F is selected as it provides DDC information.
4
Rotary switch for selecting appropriate resolution
resolution
VGA 640×480
SVGA 800×600
SVGA 800×600
SVGA 800×600
XGA 1024×768
XGA 1024×768
XGA 1024×768
SVGA 800×600
SVGA 800×600
SVGA 800×600
SXGA 1280×1024
XGA 1024×768
SXGA 1280×1024
SXGA 1280×1024
VGA 640×480
SVGA 800×600
XGA 1024×768
WXGA 1280×768
SXGA 1280×1024
software defined
(If DDC information conflicts with the
display settings, the X server termi-
nates, displaying a warning)
software defined
selectable resolutions of the UGX and AGX G
________________________________________________________________________
6. Advanced configuration
Figure 6-12
DDC active
no
no
no
no
no
no
no
no
no
yes
yes
no
Table 6-3
C
RAPHIC ARD
6-10