Table of Contents
Advertisement
6.1.4 Inserting an additional expansion card
The expansion cards are made of delicate electronic components that are extremely
sensitive to static electricity. Ordinary amounts of static from your clothes or work
environment can destroy them. Transport expansion cards only in the original packaging as
delivered from the manufacturer. Handle them only by their edges and their metal
mounting bracket. Do not touch the components nor the edge connectors that plug into the
expansion slots. Use a grounded workplace and wear a grounding wrist strap; at least,
discharge your body's static electricity by touching a grounded surface, e. g., a properly
grounded system's metal chassis.
•
Please check first the restrictions given in section
expansion card.
•
Open the case of the A
see section
6.1.1 Opening the case of Argus Processor
•
Remove the bracket on the slot you intend to use. Keep the screw you have to remove and keep the bracket
for possible further use.
•
Examine the card before removing from the anti static bag. If there is any visible damage, do not install the
card and contact Barco.
•
Do not remove the card from the anti static bag until you are ready to install it. Use a grounded workplace.
Do not lay parts on the anti static bag. Only the insides are antistatic.
•
If you are inserting a Multiport I/O Card please check the jumper settings and order of the card first, see
section
6.1.7 Multiport I/O
•
Carefully align the card's connectors with the socket and press firmly. The ISA retainer at the end of the card
must be fitted into the respective guide.
1
card
2
bracket
3
guide at ventilation case / ISA retainer
•
Secure the card on the slot with the screw you removed in step 2.
•
If you have inserted an UGX X or AGX G
switch on the board as described in section
•
If you have upgraded a system from AGX G
version of the CPU board, please refer to section
•
Replace the top cover.
After inserting an additional graphic card you have to repeat system configuration as
described in section
Barco – Argus X Terminal – DOC-3265-2 – user's manual – Revision 04 – May-2004
P
or A
RGUS
ROCESSOR
RGUS
Multiport I/O Card please check the jumper settings and order of the card first, see
card.
C
RAPHIC
ARD
6.1.5 Switching resolution of graphic
RAPHIC
3.4.2 X.11
configuration.
6.1.6 Combination rules
O
B
, depending on the board you want to insert. Please
MNI
US
or
6.1.2 Opening the case of Argus
you have to select the appropriate resolution with a rotary
C
to UGX G
ARDS
RAPHIC
6.1.8 Firmware version of the CPU
_________________________________________________________________________
6. Advanced configuration
before inserting or exchanging an
OmniBus!
Inserting an expansion card
cards.
C
you have to check the firmware
ARDS
board.
Figure 6-11
6-9
Advertisement
Table of Contents
