Table of Contents
Advertisement
Next to the air supply openings [1] there is the handle of the filter mounting [2].
In the center of the standard case there are three buttons. The upper one is the restart button [3], the one in the
middle is the lock keyboard switch [4], that serves to enable or disable keyboard input and the lower one is the
power button [13]. The two LEDs next to the switches indicate hard disk drive operating [7] respectively
power on [8].
The case for redundant operation additionally has a buzzer reset button for power module failure [5], which is
located on the top leftmost position. The restart button [3] is located between the lock keyboard switch [4]
and the power button [13] instead. On the front there is also an additional LED, indicating
failure [6].
On the right hand side there is the floppy disk drive [9], followed by the CD ROM drive [11] and below it the hard
disk drive [10a] or [10b].
The rendering processors of the distributed system are assembled accordingly. They are
delivered without CD-ROM drive and hard disk drive.
Barco – Argus X Terminal – DOC-3265-2 – user's manual – Revision 04 – May-2004
[1] there is the handle of the filter mounting [2].
On the front there is also an additional LED, indicating power module
_________________________________________________________________________
3. Getting started
3-3
Advertisement
Table of Contents
