Barco Argus X Terminal User Manual page 72

Finishing the configuration
****************************************************************
Distributed
NOTE: enter "service mmtserv"
to start the EOS X Server
****************************************************************
When configuration is completed, you can enter service mmtserv to start the X server:
eos:/opt/MMT2686/config # service mmtserv
If you operate A
partition after successful configuration, see section
Utility).
Barco – Argus X Terminal – DOC-3265-2 – user's manual – Revision 04 – May-2004
X Server setup done... Have fun!
in eXtended safety boot mode, please take care to update the backup
RGUS
X server:
ke care to update the backup
4.8.5 Backup and restore procedures (eosxs
________________________________________________________________________
3. Getting started
3-54