Never touch the contacts on the backside of a power module. There is the danger of being
harmed by residual voltage!
Furthermore the operation of the power module might be impacted by impurities!
•
Take a new power module and insert it as far as possible into the empty slot. Then screw the securing screw
[1] unless the module fits tight in the housing.
•
On the back of the O
ule. Both LED's should be lightened.
•
Readjust the ventilation flap at the front of the O
5.2.3 Replacing the filter pad of Argus OmniBus
The filter pad of the A
RGUS
Therefore proceed as follows:
•
Open the ventilation flap as explained in section
•
The filter pad is pined onto the flap. Remove it and pin a new filter in it!
•
Readjust the ventilation flap at the front of the O
As long as the filter pad is not irreversibly blocked, cleaning it with a vacuum cleaner is also
an acceptable method to maintain a good air ventilation within the system!
Barco – Argus X Terminal – DOC-3265-2 – user's manual – Revision 04 – May-2004
B
switch on the respective power switch and check the LED's on the power mod-
MNI
US
O
B
has to be changed in intervals, depending on the grade of pollution of the air.
MNI
US
B
and tighten the three screws at the upper side.
MNI
US
5.2.1 Opening the front of the Argus
B
and tighten the three screws at the upper side.
MNI
US
_________________________________________________________________________
5. Maintenance
There is the danger of being
removing the power module
OmniBus.
Figure 5-5
5-7