Firmware Version Of The Cpu Board - Barco Argus X Terminal User Manual

Forbidden PCI slots
If the Multiport I/O Card is used together with the Ethernet Card 10/100 Mbps or the Ethernet Card
10/100/1000 Mbps some restrictions concerning the used PCI slots have to be taken into a
the model of A .
RGUS
Model of Argus
AGS-3270-0, AGS-3328-0/1
The location of the PCI slots in your A
can see on the label on the back of the A

6.1.8 Firmware version of the CPU board

If UGX G C are used in an O
RAPHIC ARDS
or higher. To check the firmware version take a look at the label at the side of the CPU board. The printing on the
label looks like this or similar:
XXXXXXXXXXX
X 0.0 X
X 3153-03 X
X PCX X
XXXXXXXXXXX
If the firmware is a former release, then it must be upgraded. Please contact the Barco support, see section
Hot line.
Barco – Argus X Terminal – DOC-3265-2 – user's manual – Revision 04 – May-2004
forbidden slots for a combination of Multiport I/O Card and
Ethernet Card 10/100 hernet Card 10/100 Mbps or 10/100/1000 Mbps
PCI2 and PCI6
don't use both slots at the same time for Ethernet cards and Multiport I/O
cards.
is described in section
RGUS
housing.
RGUS
PU board
B , then the firmware of the CPU board must be version
MNI US
PCI slots have to be taken into account, depending on
3.1.1 Argus Processor. The model of the A
ware of the CPU board must be version PCX-3153-03
________________________________________________________________________
6. Advanced configuration
Table 6-10
you
RGUS
8.3
6-15