Table of Contents
Advertisement
3.2.13 Distributed system
With the distributed system multiple rendering machines are used, each one consisting of a rendering processor
and one or two O
B
MNI
US
A
sub-net.
RGUS
With the distributed system, each rendering machine operates a rectangular array of projection modules within a
display wall. The actual subdivision into arrays depends on the requirements of each display wall (e. g. displaying
video). The following figure shows an example for a 10×5 arrang
The actual assignment of rendering machines and OmniBus devices to projection modules is
defined in the configuration file of A
The rendering machines are connected to the central processor within a separate Sub-net (see also section
Network). Therefore the central processor is equipped with at least two network cards. The network card with the
lower Ethernet address, respectively the higher PCI slot number connects to the LAN
Ethernet address, respectively the lower PCI slot number connects to the Sub-net.
Barco – Argus X Terminal – DOC-3265-2 – user's manual – Revision 04 – May-2004
devices. Each rendering processor is connected to the central processor by means of the
xample for a 10×5 arrangement:
A
RGUS
A
RGUS
Example for the assignment of rendering machines and O
PCI 6 PCI 5 PCI 4 PCI 3 PCI 2 PCI 1
A
RGUS
A
RGUS
A
RGUS
. See section
6.2.6 Advanced Argus
RGUS
LAN
Sub-net
Example for network cards in the central processor
________________________________________________________________________
3. Getting started
A
RGUS
B
devices to projection modules
MNI
US
configuration.
AN, the card with the higher
Figure 3-30
3.2.12
Figure 3-31
3-24
Advertisement
Table of Contents
