Table of Contents
Advertisement
3.2.14 4 CPU board
The CPU board controls amongst other the remote power on/off mechanism between P
devices and the transmission of a genlock signal.
Connectors
On the CPU board there are two RJ-45 connectors for connecting the remote power on/off cables.
Do not remove the sheet metal plate. The connector behind is reserved for diagnostic
purposes.
Connecting order remote power on/off
All A
devices should be connected in a daisy chain for remote power on/off mechanism. Therefore the
RGUS
GUS
remote power on/off connector [16] on the back of A
power on/off in connector of the CPU board of the first A
tor of this O
B
must be connected to the remote power on/off in connector of the next O
MNI
US
The remote power on/off out connector of the last O
Do not mix up the connetors for remote power on/off with the mechanically identical
connectors of the network adapters!
Mixing the connectores will cause damage to the system.
Barco – Argus Workstation for Windows – DOC-3266-2 – Revision 06 – April 2004
/off
y chain for remote power on/off mechanism. Therefore the
RGUS
RGUS
B
MNI
US
P
must be connected with the remote
ROCESSOR
O
B
. The remote power on/off out connec-
MNI
US
remains unconnected.
_________________________________________________________________________
3. Getting started
and the O
B
ROCESSOR
MNI
Figure 3-29
connectors of CPU board
B
and so on.
MNI
US
Figure 3-30
cabling for remote power on/off
3-23
US
Advertisement
Table of Contents
