Barco Argus X Terminal User Manual page 41

Order
The network cards are inserted in sequence into the PCI slots of the A
more than one network card is built-in, they are numbered consecutively after descending PCI slots.
The Ethernet addresses are labeled on the network cards. Ethernet addresses are labeled on the network cards.
If using different types of network cards, this type determines the order as well. To get a
straight numbering of the cards the 1000 Mbps network cards should be inserted in the PCI
slots with the higher numbers followed by the 100 Mbps network cards in the PCI slots with
lower numbers.
Inserting a network card in an Argus OmniBus in not supported!
Barco – Argus X Terminal – DOC-3265-2 – user's manual – Revision 04 – May-2004
P
RGUS ROCESSOR
, this type determines the order as well. To get a
Bus in not supported!
________________________________________________________________________
3. Getting started
with the lowest numbers. If
Figure 3-29
Example for inserting LAN network cards
3-23