Upgrading System Software - Barco Argus X Terminal User Manual

6.2.3 Upgrading system software

To upgrade the system software, switch on A
Welcome Screen displays a selection of installation and upgrade options. To upgrade A
press the <Enter> key.
Before the upgrade starts just the keyboard must be specified. Select the type of the used keyboard with the
arrow keys and confirm OK. If you press Cancel a keyboard of us type becomes installed by default.
When the upgrade is finished you are prompted to press the <Enter> key to reboot A
The system will reboot now. Remove the CD from the drive as soon as the drawer ejects it. After this system
upgrade you have also to run through
Configuring a distributed system
If you operate A
still contains the backup of the working partition containing the state from before the
upgrade. If you are sure that you want to keep the new release it is recommended to make
a new backup of the system, please refer to section
Utility).
Barco – Argus X Terminal – DOC-3265-2 – user's manual – Revision 04 – May-2004
and insert the installation CD. A
RGUS
3.4.2 X.11 configuration
or 3.4.4 Configuring a distributed system with multiple logical
in eXtended safety boot mode, after the upgrade the backup partition
RGUS
RGUS
RGUS
and if you have a distributed system through
screens.
4.8.5 Backup and restore procedures (eosxs
________________________________________________________________________
6. Advanced configuration
will boot from CD . The
type upgrade and
RGUS
Figure 6-21
Figure 6-22
.
Figure 6-23
3.4.3
6-20