Table of Contents
Advertisement
2 - "OVT-2882 (ViRGE/MX)"
3 - "AGX-3000"
4 – "AGX-3281"
Enter the graphic card type
Configuring the depth resolution (Bit Per Pixel)
8
- for
8 bpp (256 colors)
16
- for 16 bpp (64K colors)
Enter the depth resolution
These are your MLS Server settings
==================================
- Core machine's second IP:
- Engines Netmask Address:
- Operational mode :
- Number engines :
- Values for engine 1:
- Values for engine 2:
Everything correct? (yes/no)? [yes]:
Finishing the configuration
After specifying the parameters for multiple logical screens the values explained in section
and section
3.4.3 Configuring a distributed system
****************************************************************
MLS X Server setup done... Have fun!
NOTE: enter "service mmtserv"
****************************************************************
When configuration is completed, you can enter service mmtserv to start the X server:
eos:/opt/MMT2686/config # service mmtserv
If you operate A
partition after successful configuration, see section
Utility).
Barco – Argus X Terminal – DOC-3265-2 – user's manual – Revision 04 – May-2004
[1]: 2
[8]: 16
192.168.1.254
255.255.255.0
Contiguous
2
IP = 192.168.1.1 Ether = 00.a0.c0.83.76.98
arrangement = 2x2
AGX-3000: Bpp = 8
IP = 192.168.1.2 Ether = 00.a0.c0.83.54.77
arrangement = 2x2
OVT-2882: Bpp = 16
must be indicated.
to start the EOS Distributed X Server
in eXtended safety boot mode, please take care to update the backup
RGUS
position = 0,0
Visual = PseudoColor
position = 2,0
Visual = TrueColor
4.8.5 Backup and restore procedures (eosxs
________________________________________________________________________
3. Getting started
3.4.2 X.11 configuration
3-56
Advertisement
Table of Contents
