Server Parameters - Barco Argus X Terminal User Manual

6.2.5 X server parameters
If you want to make changes to the graphical user interface X.11, which are not supported by the configuration
tools introduced in section
with a large number of options.
there are manual pages about the Xserver available. For reading these man pages enter man
On A
RGUS
Xserver in the command line:
# man Xserver
Additional options are listed in the table below:
-no_cursor_on_video
-ddc_all
-no_ddc
The desired options must be entered manually each in a single line in the file:
/etc/MMTconfig/MMTServerConfig
X Server parameters that shall not be changed at a new run of the script EOSconfig can be entered between the
two lines:
# BeginSection Private
# EndSection
The file MMTServerConfig contains already lines inserted automatically by the configuration
script. Do not change these entries manually.
Barco – Argus X Terminal – DOC-3265-2 – user's manual – Revision 04 – May-2004
3.4.2 X.11 configuration, you can manipulate the appearance and the properties of X.11
The cursor becomes invisible, as long as it is moved over videos.
DDC detection is asked for every graphic channel. Each graphic channel
needs up to 6 seconds for detection. Therefore this should not be used
as a standard, see section
DDC detection is not done at all.
6. Advanced configuration
4.8.2 DDC utility.
________________________________________________________________________
Table 6-12
6-22