Table of Contents
Advertisement
5.2 Argus OmniBus
5.2.1 Opening the front of the Argus OmniBus
All servicing of the O
B
MNI
necessary to open the ventilation flap at the front. This flap can be opened during operation to do some hot-plug
operations.
WARNING: Hazardous moving parts! Keep fingers and other body parts away!
ING: Hazardous moving parts! Keep fingers and other body parts away!
Behind the ventilation flap on the upper front there are the fans located. These fans are spinning
very fast. When opening the flap they are no longer powered, nevertheless they need some time
to spin out. During this period they still have the ability to harm you. Do not stick your fingers or
objects into the fans!
Be very careful, when opening the flap! The fans are close to the screws you loosened before. Do
not stick your fingers into the OmniBus to open the flap!
After opening the flap, wait until the fans have stopped spinning before touching anything at the
front of the OmniBus!
When opening the ventilation flap of the Argus OmniBus, the ventilation fans will stop and
the cooling of the device is interrupted as long as the flap is open. Therefore the flap should
not be open longer than 5 minutes, to guarantee at all times sufficient cooling!
•
Remove the screws [1], see
Phillips screwdriver!
•
Open the flap, by turning it downwards and remove it!
•
With the flap removed there is access to the three fans and to the one or two power modules, please see
the figure below:
1
1, 2, 3
securing screw of fan 1, 2 and 3
4 (, 5)
securing screw of power module 1 (and optional redundant power module 2)
•
When servicing is done do not forget to readjust the ventilation flap at the front of the O
tighten the three screws at the upper side.
Barco – Argus X Terminal – DOC-3265-2 – user's manual – Revision 04 – May-2004
mniBus
is done at the front side of the device. Therefore for maintenance of the O
US
Figure 3-5 Front of the Argus OmniBus
1
2
4
2 and 3
Bus, the ventilation fans will stop and
on the upper front of A
2
3
5
_________________________________________________________________________
5. Maintenance
B
MNI
US
O
B
with a
RGUS
MNI
US
3
Figure 5-3
Front of A
O
B
, view inside
RGUS
MNI
US
B
and to
MNI
US
it is
5-5
Advertisement
Table of Contents
