Table of Contents
Advertisement
Setting the Eos FireWall Policies
=================================
If you want to configure the Eos as secure
X Terminal, choose the policy "high"
then only X11-Connection are permitted
Choose one of the FireWall Policies
-----------------------------------
1 - "High"
2 - "Medium"
3 - "Disable"
4 - "Don't change the existing FireWall Policy"
Enter the FireWall Policies
You have chosen the FireWall Policy "Medium"
Is this correct? (yes/no)? [yes]:y
Finishing the configuration
If you do install a single A
uring a distributed system you have to specify the data for the central device and the rendering machines. See
section
3.4.3 Configuring a distributed
***********************************************************************
*
*
The EOS-X configuration is finished now, please enter your choice
*
***********************************************************************
1
Exit configuration (all your current entries will be lost)
2
Finish configuration
Enter your X Server Configuration
The EOS-X System will be configured now.
***************************************************************
Multiscreen X Server setup done... Have fun!
NOTE: enter "service mmtserv"
to start the EOS X Server
****************************************************************
When configuration is completed, you can enter service mmtserv to start the X server:
eos:/opt/MMT2686/config # service mmtserv
If you operate A
partition after successful configuration, see section
Utility).
Barco – Argus X Terminal – DOC-3265-2 – user's manual – Revision 04 – May-2004
[2]: 2
, configuration is done and the script is finished with the next step. When config-
RGUS
system.
[2]:2
in eXtended safety boot mode, please take care to update the backup
RGUS
Please wait ...
4.8.5 Backup and restore procedures (eosxs
________________________________________________________________________
3. Getting started
*
*
*
ke care to update the backup
3-50
Advertisement
Table of Contents
