Installing System Software On The Hard Drive - Barco Argus X Terminal User Manual

6.2.2 Installing system software on the hard drive

Usually A comes with preinstalled system software. In case you want to reinstall the system software or
RGUS
install a new hard disk, please follow the instructions in this section.
Installation
Switch on A and insert the system CD. A
RGUS
installation options. Select the type for your installation and enter the required keyword.
•
A in eXtended safety boot mode:
RGUS
press the <Enter> key
•
A in normal boot mode:
RGUS
type eosn and press the <Enter> key
•
Upgrade A :
RGUS
please see section 6.2.3 Upgrading system
After selecting the type of your installation, you are asked if you really want to delete the partitions and install
the system software. If you want to skip the installation you can press <alt><ctrl><delete> simultane-
ously. If you want to install you must confirm with y <cr> and the A
When the system software is installed just the keyboard and the IP address of the primary network card must be
specified. Select the type of the used keyboard with the arrow keys and confirm OK. If you press Cancel a key-
board of us type becomes installed by default.
Barco – Argus X Terminal – DOC-3265-2 – user's manual – Revision 04 – May-2004
will boot from CD. The Welcome Screen displays a selection of
RGUS
software!
just the keyboard and the IP address of the primary network card must be
6. Advanced configuration
operating system is getting installed.
RGUS
________________________________________________________________________
Figure 6-14
Figure 6-15 5
6-17