Omniscaler - Barco Argus X Terminal User Manual

3.2.6 OmniScaler

In addition to graphic cards, also O
O S provide the ability to integrate video and RGB data into the graphical data from the graphic cards.
MNI CALERS
Therefore the out connector of the graphic card needs to be connected to the in connector of the O
Only graphic cards in digital mode can be connected. DDC information from the projection device is looped
through to the graphic card for further processing.
The O S exists in two versions. O
MNI CALER
Within one system both types of O
below are considered:
OmniScaler
AGX-3002
AGX-3313
Connectors
The O S provides one Dual-DVI connector for data insertion from the graphic card and one Dual-DVI con-
MNI CALER
nector for digital output for two projection modules.
In every O S card package a Dual-DVI to Dual-DVI cable is included. It serves to connect
MNI CALER
O S with port 0/1 or port 2/3 of the graphic card:
MNI CALER
For the connection to the projection modules the Dual-DVI to 2×DVI-D adapter cable that was provided with the
graphic card is used. It must be plugged into port 0/1 out of the O
Barco – Argus X Terminal – DOC-3265-2 – user's manual – Revision 04 – May-2004
S are a substantial part of A
MNI CALERS ERS
S
MNI CALER
S can be used. provided that the requirements given in the table
MNI CALERS
maximal resolution / channel
SXGA
UXGA
to connect to projection modules. The
RGUS
DDC information from the projection device is looped
AGX-3313 is a replacement for the O
required display driver
R 3.0 and higher 3.0 and higher
R 3.3 and higher
ble is included. It serves to connect port 0/1 in of the
S .
MNI CALER
________________________________________________________________________
3. Getting started
S AGX-3002
MNI CALER
Compatibility matrix of O S
MNI CALER
ports of the O
Dual-DVI to Dual-DVI adapter cable
S .
MNI CALER
002.
Table 3-1
versions
Figure 3-20
S
MNI CALER
Figure 3-21
3-15