Adjusting The Carriage Speed; Checking The Nozzle Check Pattern; Adjustment - Brother GTX-4 Service Manual

Adjustment

1

Adjusting the carriage speed

Perform the operation while the printer is in Standby mode.
1) -> [Printer Setting] -> [CR Speed Adjustment] ->
[Start (after cleaning/setup)] ->
minutes.)
2) When the printer stops with a sound and the printer returns
to Standby mode, the operation is completed.
23
2
1) Make sure that the platen height adjustment lever (a) is set
(It takes about 3

Checking the nozzle check pattern

at the "A" position.
(a)
Use a platen sized 14 in. x 16 in. (356 mm x 406
mm), which is included at the time of your
TIPS
purchase.
X0154