Level Setting For Top Surface Of Platen - Brother GTX-4 Service Manual

6-1-11. Level setting for top surface of platen

(1) Press on the control panel to advance platen.
(2) Select the [Output Check] from the Advanced menu and select the [Carriage Test] > [To Center]. Press and hold
down the power button to power off.
<IMPORTANT>

Please complete the task within 1 hour, in order to prevent the print heads from drying up.
Long-hour continuation of a head without capping may lead to non-ejection of ink-jet droplets.
Advabced Menu
Exchange Filter
Setting special work mode
Output Check
Input Check
Print Position Adjust
Carriage Test
To Cap Position
To Flushing Position
To Center
(3) Reset settings for platen bearing, collars and spacers to their initial condition.
(4) Set platen height adjustment lever to position A.
(5) Move platen to position the center of the component below the print head (color-side).
Output Check
Wiper Test
Carriage Test
Solenoid Test
OK
Platen
Platen height adjustment lever
6-28
Disassembly / Replacement / Adjustment