Brother GTX-4 Service Manual page 483

Hide thumbs Also See for GTX-4:

Table of Contents

Setup of the printer

Tuck the extra cable into the space as shown in area (e) for the

To eliminate the slack of the flat cable on the resin cover side,

hold the cable down by using a clip as shown in a.

Hook the two claws of the resin cover to mount the cover.

Remove four caps of the head.

Check that the head and the marker of each tube are matched

and connect the tubes one by one from back to front of the

machine by rotating the nut until it stops.

Do not rotate the nut as illustrated in (f). It could

disconnect the tube and leak the contained ink.

Be sure to remove the caps attached to the

head before connecting.