Brother GTX-4 Service Manual page 107

Hide thumbs Also See for GTX-4:

Table of Contents

Use the clean stick R to clean off any ink debris attached to the hole on the bottom of flushing receiver.

For this cleaning, you can use an already-used dirty clean stick R.

Assemble a new flushing foam to the flushing receiver.

After this assembly process is completed, make sure that no flushing foam extends off the outboard end portions of flushing

receiver. If it sticks out of the end portions, it may interfere with any nozzles and may result in non-ejection of ink-jet

Mount the flushing receiver back to its original place in the maintenance unit.

Direct its orientation with a hole on the bottom to the front.

Close the front cover.

Turn on the power.

Dispose of any waste resulting from the replacement in accordance with applicable laws and ordinances.

The head cleaning will be performed to prevent ink from drying up.

Outboard end portions

Improvement of print quality

Clean stick R

Flushing receiver