(11) After cleaning the surrounding areas of wiper and nozzle surface, is such failure cleared?
Clean the surrounding areas of wiper and nozzle surface.
Clean the wiper.
(1)
Use clean stick R to wipe clean the surface of the wiper as well as the gap between the convex part and the wiper.
<IMPORTANT>
Never touch the tip end of clean stick R with your hand. If any sebaceous matter is attached to the wiper, it may result in a
printer malfunction.
The clean stick R used for cleaning the nozzle guard should be rinsed in the cleaning cup before the next use. Be sure to
use the clean stick R separately for color ink and white ink.
(2)
Use the clean side of clean stick R to wipe clean the back of the wiper.
Front
Convex part
(3)
Rinse the clean stick R in the cleaning cup to use it for cleaning of the exhaust cap to be performed next.
<IMPORTANT>
Be sure to use the clean stick R separately for white ink and color ink.
(4)
Print out a nozzle check pattern to check the result.
If non-ink ejection nozzle is not found -> OK
If the state of non-ink ejection nozzle is not changed -> NG
=> "(12) After replacing the wiper cleaner, is such failure cleared?"
Clean stick R
Clean stick R
Wiper
Front
4-48
Improvement of print quality
Wiper
Back
X0195