Brother GTX-4 Service Manual page 380

Hide thumbs Also See for GTX-4:

Table of Contents

Remove the two screws fixing the encoder circuit board to detach it.

While passing the encoder strip through the encoder slit, use two screws to temporarily fix the encoder circuit board.

Align the end of the encoder circuit board to the edge of the carriage base, adjust the position of the circuit board so

that the encoder strip may not contact the encoder, and then securely tighten the screws.

Connect the encoder relay connector.

Use the two cord holder to fix the encoder circuit board harness.

Disassembly / Replacement / Adjustment