Brother GTX-4 Service Manual page 366

Hide thumbs Also See for GTX-4:

Table of Contents

To perform the assembly, take the reverse procedures to disassembly operation. For the way to connect the FPC,

refer to the description mentioned below.

Connecting FPC

Draw the latches on both sides of "Black resin" to release the lock and insert the FPC.

Take care to protect the FPC contact point (metal surface) from greasy dirt and being scratched.

Take care so that your fingers may not touch the FPC contact point (metal surface).

Push the latches on both sides of "Black resin" at the same time to release the lock.

At this time, make sure that the FFC is properly inserted.

Re-adjust firmware according to the following procedures upon completing assembly.

Activate GTX-4 Service Tool,

and select in the sequence of Parts replacement processing > Next > LCD Circuit Board > Next

then comply with instructions displayed within the GTX-4 Service Tool.

Disassembly / Replacement / Adjustment