Adjustment; Cr (Carriage) Speed Adjustment - Brother GTX-4 Instruction Manual

7-4. Adjustment

7-4-1. CR (Carriage) speed adjustment

Carriage speed should be adjusted when the error message [Adjust CR] is displayed on the operation panel. Adjustment
should always be performed when carriage shaft cleaning or print head replacement tasks are carried out, or after
completing the setup procedures.
(1) While the printer is in standby mode, press
(2) From the menu, select [Printer Setting] > [CR Speed Adjustment], and press
(3) Select [Start] or [Start (after cleaning/setup)] and press

[Start]: If you cannot clean the internal area of the printer such as carriage shaft immediately after the head
replacement or when the error message is displayed.

[Start (after cleaning/setup)]: After cleaning the carriage shaft.
Wait until the carriage stops moving and the sound of pong is heard.
It takes about 3 minutes to adjust the carriage speed.
Precautions to keep good printing quality/use printer over the long term
on the operation panel to bring the menu screen into view.
.
214
.