Interface Commands - SMC Networks SMC TigerStack IV SMC6224M Management Manual

C L
OMMAND INE

Interface Commands

These commands are used to display or set communication parameters for
an Ethernet port, aggregated link, or VLAN.
Command
interface
description
speed-duplex Configures the speed and duplex operation of a
negotiation
capabilities
flowcontrol
shutdown
switchport
broadcast
packet-rate
clear counters Clears statistics on an interface
show
interfaces
status
show
interfaces
counters
show
interfaces
switchport
4-142
I
NTERFACE
Table 4-40 Interface Commands
Function
Configures an interface type and enters interface
configuration mode
Adds a description to an interface configuration IC
given interface when autonegotiation is disabled
Enables autonegotiation of a given interface
Advertises the capabilities of a given interface for
use in autonegotiation
Enables flow control on a given interface
Disables an interface
Configures the broadcast storm control
threshold
Displays status for the specified interface
Displays statistics for the specified interfaces
Displays the administrative and operational
status of an interface
Mode Page
GC 4-143
4-143
IC 4-144
IC 4-145
IC 4-146
IC 4-147
IC 4-148
IC 4-149
PE 4-150
NE, 4-151
PE
NE, 4-152
PE
NE, 4-154
PE