Snmp Commands; Snmp-Server Community - SMC Networks SMC TigerStack IV SMC6224M Management Manual

SNMP Commands

Controls access to this switch from management stations using the Simple
Network Management Protocol (SNMP), as well as the error types sent to
trap managers.
Command
snmp-server
community
snmp-server
contact
snmp-server
location
snmp-server host Specifies the recipient of an SNMP
snmp-server
enable traps
show snmp

snmp-server community

This command defines the community access string for the Simple
Network Management Protocol. Use the no form to remove the specified
community string.
Syntax
snmp-server community string [ro|rw]
no snmp-server community string
• string - Community string that acts like a password and permits
access to the SNMP protocol. (Maximum length: 32 characters,
case sensitive; Maximum number of strings: 5)
• ro - Specifies read-only access. Authorized management stations are
only able to retrieve MIB objects.
Table 4-39 SNMP Commands
Function
Sets up the community access string to permit
access to SNMP commands
Sets the system contact string
Sets the system location string
notification operation
Enables the device to send SNMP traps (i.e.,
SNMP notifications)
Displays the status of SNMP communications NE,
SNMP C
OMMANDS
Mode Page
GC 4-135
GC 4-136
GC 4-137
GC 4-138
GC 4-139
4-140
PE
4-135