Dot1X Timeout Tx-Period; Show Dot1X - SMC Networks SMC TigerStack IV SMC6224M Management Manual

C L
OMMAND INE
Example
Console(config)#interface eth 1/2
Console(config-if)#dot1x timeout re-authperiod 300

dot1x timeout tx-period

This command sets the time that an interface on the switch waits during an
authentication session before re-transmitting an EAP packet. Use the no
form to reset to the default value.
Syntax
dot1x timeout tx-period seconds
no dot1x timeout tx-period
seconds - The number of seconds. (Range: 1-65535)
Default
30 seconds
Command Mode
Interface Configuration
Example
Console(config)#interface eth 1/2
Console(config-if)#dot1x timeout tx-period 300

show dot1x

This command shows general port authentication related settings on the
switch or a specific interface.
Syntax
show dot1x [statistics] [interface interface]
• statistics - Displays dot1x status for each port.
• interface
• ethernet unit/port
4-112
I
NTERFACE
-unit - Stack unit.
(Range – SMC6224M: 1-8, SMC6248M: 1-4, mixed stack: 1-4)
-port - Port number. (Range: 1-26/50)