Spanning-Tree Pathcost Method; Spanning-Tree Transmission-Limit - SMC Networks SMC TigerStack IV SMC6224M Management Manual

C L
OMMAND INE

spanning-tree pathcost method

This command configures the path cost method used for Rapid Spanning
Tree. Use the no form to restore the default.
Syntax
spanning-tree pathcost method {long | short}
no spanning-tree pathcost method
• long - Specifies 32-bit based values that range from 0-200,000,000.
• short - Specifies 16-bit based values that range from 0-65535.
Default Setting
Long method
Command Mode
Global Configuration
Command Usage
The path cost method is used to determine the best path between
devices. Therefore, lower values should be assigned to ports attached to
faster media, and higher values assigned to ports with slower media.
Note that path cost (page 4-188) takes precedence over port priority
(page 4-189).
Example
Console(config)#spanning-tree pathcost method long
Console(config)#

spanning-tree transmission-limit

This command configures the minimum interval between the transmission
of consecutive RSTP BPDUs. Use the no form to restore the default.
Syntax
spanning-tree transmission-limit count
no spanning-tree transmission-limit
count - The transmission limit in seconds. (Range: 1-10)
4-186
I
NTERFACE