Enabling Snmp Management Access - SMC Networks SMC TigerStack IV SMC6224M Management Manual

2. At the interface-configuration mode prompt, use one of the following
commands:
•
•
3. Type "end" to return to the Privileged Exec mode. Press <Enter>.
4. Type "ip dhcp restart" to begin broadcasting service requests.
Press <Enter>.
5. Wait a few minutes, and then check the IP configuration settings by
typing the "show ip interface" command. Press <Enter>.
6. Then save your configuration changes by typing "copy running-config
startup-config." Enter the startup file name and press <Enter>.
Console(config)#interface vlan 1
Console(config-if)#ip address dhcp
Console(config-if)#end
Console#ip dhcp restart
Console#show ip interface
IP address and netmask: 192.168.1.54 255.255.255.0 on VLAN 1,
and address mode: User specified.
Console#copy running-config startup-config
Startup configuration file name []: startup
\Write to FLASH Programming.
\Write to FLASH finish.
Success.

Enabling SNMP Management Access

The switch can be configured to accept management commands from
Simple Network Management Protocol (SNMP) applications such as
SMC EliteView. You can configure the switch to (1) respond to SNMP
requests or (2) generate SNMP traps.
To obtain IP settings via DHCP, type "ip address dhcp" and press
<Enter>.
To obtain IP settings via BOOTP, type "ip address bootp" and
press <Enter>.
B C
ASIC ONFIGURATION
2-11