Checking The Oil Level Of The Rear Axle; Changing The Oil In The Rear Axle; Checking The Lubricant In The Gear Box Of The Rear Axle - Toro Reelmaster 7000-D Operator's Manual

Figure 95
4. Repeat steps 1 through
the Planetary-Gear-Drive (page 62)
steps 1 through 3
planetary/brake assembly at the other side of
the machine.
Checking the Oil Level of
the Rear Axle
Service Interval: Every 400 hours
The rear axle is shipped from the factory filled with
SAE 85W-140 gear lube. Check the oil level before
the engine is first started and every 400 hours
thereafter. The capacity is 2.4 L (80 fl oz). Visually
inspect for leaks daily.
1. Park the machine on a level surface, lower the
cutting units, engage the parking brake, shut off
the engine, and remove the key.
2. Remove a check plug from 1 end of the axle
(Figure 96) and make sure that the oil is up to
the bottom of the hole. If the level is low, remove
the fill plug (Figure
bring the level up to the bottom of the check-plug
holes.
Figure 96
1. Check plug
7 in Draining
and
in this procedure for the
96) and add enough oil to
2. Fill plug
Changing the Oil in the
Rear Axle
Service Interval: After the first 200 hours
Every 800 hours
1. Park the machine on a level surface, lower the
cutting units, engage the parking brake, shut off
the engine, and remove the key.
2. Clean the area around the 3 drain plugs, 1 on
each end and 1 in the center
g225607
1. Drain plugs
3. Remove the oil-level-check plugs and the main
axle vent cap to ease in draining of the oil.
4. Remove the drain plugs and allow the oil to drain
into the pans.
5. Install the plugs.
6. Remove a check plug and fill the axle with
approximately 2.37 L (80 fl oz) of 85W-140 gear
lube or until the oil is up to the bottom of the hole.
7. Install the check plug.
Checking the Lubricant in
the Gear Box of the Rear
Axle
Service Interval: Every 400 hours
The gear box is filled with SAE 85W-140 gear lube.
Check the oil level before the engine is first started
and every 400 hours thereafter. The capacity is 0.5 L
(16 fl oz). Visually inspect for leaks daily.
1. Park the machine on a level surface, lower the
cutting units, engage the parking brake, shut off
the engine, and remove the key.
g009716
2. Remove the check/fill plug from the left side of
the gear box
lubricant is up to the bottom of the hole. If the
63
(Figure
Figure 97
(Figure 98) and make sure that
97).
g009717