Operation; Media Loading; Operation 4.1 Media Loading; Loading The Sheet Media - GCC Technologies Expert Pro Series User Manual

Hide thumbs Also See for Expert Pro Series:

Table of Contents

Chapter 4 Operation

4.1

To load the media properly, please follow the procedures listed below:

Pull the lever upward to raise the pinch rollers. (Figure 4-1)

Load your media on the platen and slide it under the pinch rollers from either the front side or

the backside. The alignment rulers on the platen extension will help you to adjust the media

precisely.

Note:

Be sure that the media must be covered by the paper sensors on the

platen when loading the media. At least one of the two paper sensors

should be covered. Once the media covers the sensor, the cutting plotter

will size width and length of media automatically.

Then move the pinch rollers manually to the proper position. Be sure the pinch rollers must be

positioned above the grid drum. The white marks on top trail will help you position pinch rollers

when media on the platen. (Figure 4-2)

Operation

Paper sensor

Figure 4-1

4-1

Expert Pro User Manual

Table of Contents

Show Quick Links

Table of Contents