Link Configuration Selection - Agilent Technologies 7100 User Manual

Link Configuration Selection

The LAN interface supports 10 or 100 Mbps operation in full or half-duplex
modes. In most cases, full-duplex is supported when the connecting network
device - such as a network switch or hub - supports IEEE 802.3u
auto-negotiation specifications.
When connecting to network devices that do not support auto-negotiation, the
LAN interface will configure itself for 10 or 100-Mbps half-duplex operation.
For example, when connected to a non-negotiating 10-Mbps hub, the LAN
interface will be automatically set to operate at 10-Mbps half-duplex.
If the CE instrument is not able to connect to the network through
auto-negotiation, you can manually set the link operating mode using link
configuration switches on the CE instrument.
Table 20
Agilent 7100 Capillary Electrophoresis System User Manual
Link configuration switches
SW3
OFF
ON
ON
ON
ON

Link Configuration Selection

SW4 SW5 Link configuration
- - Speed and duplex mode determined by
auto-negotiation
OFF OFF Manually set to 10 Mbps, half-duplex
OFF ON Manually set to 10 Mbps, full-duplex
ON OFF Manually set to 100 Mbps, half-duplex
ON ON Manually set to 100 Mbps, full-duplex
LAN Configuration
69
4