With Telnet - Agilent Technologies 7100 User Manual

4 LAN Configuration
Manual Configuration

With Telnet

Whenever a TCP/IP connection to the 7100 CE instrument is possible (TCP/IP
parameters set by any method), the parameters may be altered by opening a
Telnet session. Please refer to
initial LAN connection.
1 Open the system (DOS) prompt window by clicking the Windows START
2 Type the following after the system (DOS) prompt:
Figure 8
where <IP address> may contain the assigned address from a Bootp cycle, or
the default IP address (see
If the connection is established successfully, the instrument responds with the
following:
Figure 9
72
button and select "Run...". Type "cmd" and press OK.
•
c:\>telnet <IP address>
or
•
c:\>telnet <host name>
Telnet - starting a session
A connection to the instrument has been made
"Using Default"
"Configuration Switch"
Agilent 7100 Capillary Electrophoresis System User Manual
on page 67 for establishing an
on page 64).