Changing The Resolution - Siemens SITRANS F series Operating Instructions Manual

Operating
7.3 Reading / changing parameters
Table 7- 8
Key
Note
Ensure that the new value is within the minimum/maximum range when changing numeric
values.
Note
##### signs in display
The display is unable to show the measured value. Change the measurement units or the
resolution.
7.3.1.1

Changing the resolution

In order to change the resolution of the process value shown in the operation view (for
example mass flow), set the decimal places parameter for the selected process value, for
example the decimal places for process value Mass flow is defined in Decimal places
(2.2.2.4).
The resolution can also be changed by changing the resolution of one configuration
parameter for this process value (for example Low flow cut-off (2.2.2.5)). Any changes in
resolution will change the resolution of all configuration parameters for this process value as
well.
80
Key functions - editing alphanumeric values
Function
Select the next left position.
If the most left position is selected: exit the parameter edit view without confirming the
changes. Keep pressing the key to jump to the most left position.
Change the selected number/character.
Numeric characters: increase the number by one (for example from 7 to 8)
ASCII characters: select the previous character in the alphabet.
Change the selected number/character.
Numeric characters: decrease the number by one (for example. from 8 to 7)
ASCII characters: select the next character in the alphabet.
Select the next right position.
If most right position is selected: confirm the change and exit the parameter edit view.
Keep pressing the key to jump to the most right position.
SITRANS F Ultrasonic flowmeters FST030 (Modbus)
Operating Instructions, 08/2017, A5E37367739-AC