Siemens SITRANS F series Operating Instructions Manual page 352

SIMATIC PDM
C.1 Commissioning with PDM
Drop-down menus
Table C- 1
Device menus
Communication Path
Communication (Modbus)
Download to Device
Upload to PC/PG
Update Diagnostic Status
Set Address
Wizard - Quick Start
Wizard - Clamp-On Configuration...
Wizard - Inline Configuration...
Trim Signal Output (online dialog)
Totalizer (online dialog)
Multipoint calibration
FW update
Maintenance (online dialog)
Suppress Alarms
Audit Trail
Simulation (online dialog)
Access Management
Reset (online dialog)
Table C- 2
View menus
Process Variables (online dialog)
Device Diagnostic (online dialog)
Advanced diagnostics
350
Device menus
View menus
Description
Shows the communication interface (HART modem)
Shows the communication interface (Modbus interface)
Downloads all writable parameters to the device
Uploads all parameters from the device to the parameter
table
Reads current diagnostic status from the device and
updates the diagnostic status icon
Sets the HART polling address
Guide for a quick commissioning
Guide for a configuration of clamp-on sensors
Guide for a configuration of inline sensors
Calibration of current output (channels 2 to 4)
Controlling totalizers 1, 2 and 3
The multipoint calibration allows the user to set a calibra-
tion curve, if deemed necessary, at various flow rates
across the range of operation
A FW update is a firmware update. This function allows
the user to install firmware that has been placed on the
SD-card
Setup of maintenance functions
Suppresses individual alarms
Lists parameter changes, FW updates, and alarm history
logs
Simulation of process values, alarms, and inputs/outputs
(channels 2 to 4)
Possibility to upgrade access level from User to Expert
and to change PIN code for "expert" level
Resets device to default settings or restarts device
Description
Shows all process values
Shows all diagnostics information (alarms and advanced
diagnostic parameters)
Advanced diagnostics provides the user with operational
information to assist in determining that the device is
functioning properly, producing quality data, or assist in
troubleshooting
SITRANS F Ultrasonic flowmeters FST030 (Modbus)
Operating Instructions, 08/2017, A5E37367739-AC