Integrating The Fst030 With Modbus System - Siemens SITRANS F series Operating Instructions Manual

Connecting

5.4 Integrating the FST030 with Modbus system

④
⑤
⑥
⑦
⑧
⑨
⑩
⑪
⑫
⑬
⑭
⑮
⑯
Figure 5-1
See also
Approvals (Page 121)
Installation in hazardous areas (Page 20)
5.4 Integrating the FST030 with Modbus system
This chapter provides information on how to integrate the device in a point-to-point or
multidrop Modbus RTU network in non-hazardous or hazardous areas. Many details of
network design are beyond the scope of these operating instructions. The points below
provide an overview of the major design criteria. For further details contact Siemens.
If the device is integrated in a hazardous area, two flameproof conduit seals per device must
be installed; one at the device in the hazardous area and one in the non-hazardous area,
see System configuration (Page 37).
36
Serial no. Transmitter serial number
System revisions System revision numbers; firmware (FW) and hardware (HW)
Power Supply Power supply
Material/Version Transmitter housing material and style (compact/remote)
Conduit / cable Type of conduit / cable entries
entries
Enclosure IP / Degree of protection / Ambient temperature
Ambient temp.
Year of Manufac- Manufacturing year
ture More detailed manufacturing date information is given in the serial
number (see sensor identification nameplate above)
SW function Software function
Ch1 Communication interface on channel 1
Ch2 Input/output setup of channels 2 to 6, if ordered
Ch3
Ch4
Ch5
Ch6
WEEE symbol, see Disposal (Page 86)
Consult the Operating Instructions
C✓ / QR-code C-tick logo and product-specific QR-code
Transmitter nameplate example
SITRANS F Ultrasonic flowmeters FST030 (Modbus)
Operating Instructions, 08/2017, A5E37367739-AC